getting-started-zybo.md

@@ -159,27 +159,25 @@ Make sure that **JP14** is configured to use **USB** as power source. Furthermor
 
 ### 5.2.4 Test the Application
 
-Finally, right click on the **blink_led** project and click on **Run as -> Run Configurations**. Double click on **Xilinx C/C++ application (GDB).
+Right click on the **blink_led** project and click on **Run as -> Run Configurations**. Double click on **Xilinx C/C++ application (GDB).
 
 ![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-zybo/img/tutorial_zybo23.png)
 
-Click on the **STDIO Connection** tab. Check the **Connect STDIO to Console** checkbox
+Click on the **STDIO Connection** tab. Check the **Connect STDIO to Console** checkbox. Choose the appropriate Com Port and set the Baud Rate to **115200**. 
 
-In the **Project Manager** toolbar click the **Open Hardware Manager** button which can be found in the Program and Debug subsection.
+![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-zybo/img/tutorial_zybo24.png)
 
-![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-basys3/img/tutorial_basys7.png)
+Click **Apply**, then click **Close**. Now Click on **Xilinx Tools -> Program FPGA**. A window pops up. Leave the default options and click **Program**.
 
-Click on the **Auto Connect** submenu of the **Open target** button.
+![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-zybo/img/tutorial_zybo25.png)
 
-![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-basys3/img/tutorial_basys8.png)
+After the bitstream is sucessfully flashed onto the FPGA the DONE LED (**LD10**) lights up.  Now click on the run Button the start the application. 
 
-Finally, click on **Program Device -> xc7a35t_0**. A window pops up. Click on **Program**.
+![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-zybo/img/tutorial_zybo26.png)
 
-![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-basys3/img/tutorial_basys9.png)
+The console prompts you to enter a value between 0-15.  Type 8 and hit enter.  **LD3** starts to blink.  Type 15 and hit enter.  **LD0-  LD3** start to blink.   Type 0 and hit enter.  The LEDs stop to blink.
 
-After the bitstream is downloaded successfully the **DONE** LED of the Board should light up.  Switch **SW0** into the up position. **LD0** starts to blink. Switch **SW0 - SW15** into the up position. **LD0-LD15** blink synchronously.
-
-This concludes the Basys3 Getting Started tutorial.
+This concludes the ZyboGetting Started tutorial.
 
 
 ***