getting-started-zybo.md

@@ -153,9 +153,9 @@ Browse to the location of the downloadand and extracted GettingStartedZybo.zip f
 
 ### 5.2.2.3 Board Setup
 
-Make sure that **JP14** is configured to use **USB** as power source. Furthermore, make sure **JP5** is configured to the **JTAG** mode. Insert a micro USB cable to **J11** and connect it to your PC. Make sure that the switches **SW0 - SW15** are in the off position.
+Make sure that **JP14** is configured to use **USB** as power source. Furthermore, make sure **JP5** is configured to the **JTAG** mode. Insert a micro USB cable to **J11** and connect it to your PC.
 
- Finally, switch **SW16** to the on position. 
+ Finally, switch **SW4** to the on position. 
 
 ![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-zybo/img/GettingStartedZyboHW.png)