getting-started-zybo.md

@@ -103,13 +103,21 @@ In the design tab click on **Sources**. Right click on **Constraints** and click
 
 ![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-zybo/img/tutorial_zybo13.png)
 
-In the **Flow Navigator** toolbar click the **Generate Bitstream** button which can be found in the Program and Debug subsection. A window pops up. Click on **Yes**.
+In the **Sources** tab right click on **blink_led_zybo_bd** and click on **Generate Output Products**. A window pops up, click on **Generate**. After completion click on **OK**.
 
-![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-basys3/img/tutorial_basys5.png)
+![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-zybo/img/tutorial_zybo14.png)
+
+In the **Sources** tab right click on **blink_led_zybo_bd** and click on **Create HDL wrapper**. Leave the default option, **Let Vivado manage wrapper and auto-update**. Click **OK*.
+
+In the **Flow Navigator** toolbar click the **Generate Bitstream** button which can be found in the Program and Debug subsection. A window pops up. Click on **Save**. Another window pops up. Click on **Yes**.
+
+![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-zybo/img/tutorial_zybo15.png)
 
 A window should pop up once the bitstream generation finished successfully. Click on **Cancel**.
 
-### 5.2.2 Board Setup
+### 5.2.2 Xilinx SDK
+
+### 5.2.3 Board Setup
 
 Make sure that **JP2** is configured to use **USB** as power source. Furthermore, make sure **JP1** is configured to the **JTAG** mode. Insert a micro USB cable to **JC4** and connect it to your PC. Make sure that the switches **SW0 - SW15** are in the off position.
 
@@ -118,7 +126,7 @@ Make sure that **JP2** is configured to use **USB** as power source. Furthermore
 ![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-basys3/img/tutorial_basys6.png)
 
 
-### 5.2.3 Test the Application
+### 5.2.4 Test the Application
 
 In the **Project Manager** toolbar click the **Open Hardware Manager** button which can be found in the Program and Debug subsection.