getting-started-basys3.md

@@ -64,7 +64,7 @@ A window should pop up once the bitstream generation finished successfully. Clic
 
 ### 5.2.2 Board Setup
 
-Make sure that **JP2** is configured to use **USB** as power source. Furthermore, make sure **JP1** is configured to the **JTAG** mode. Insert a micro USB cable to JC4 and connect it to your PC. Make sure that the switches **SW0 - SW15** are in the off position. Finally, switch **SW16** to the on position. 
+Make sure that **JP2** is configured to use **USB** as power source. Furthermore, make sure **JP1** is configured to the **JTAG** mode. Insert a micro USB cable to **JC4** and connect it to your PC. Make sure that the switches **SW0 - SW15** are in the off position. Finally, switch **SW16** to the on position. 
 
 ![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-basys3/img/tutorial_basys6.png)