Skip to content

Changes

Page history
reisner: Add link to Basys3 tutorial authored by Christopher Reisner's avatar Christopher Reisner
Show whitespace changes
Inline Side-by-side
getting-started-basys3.md
View page @ 4df1da18
......@@ -64,14 +64,16 @@ A window should pop up once the bitstream generation finished successfully. Clic
### 5.2.2 Board Setup
Make sure that **JP2** is configured to use **USB** as power source. Furthermore, make sure **JP1** is configured to the **JTAG** mode. Insert a micro USB cable to **JC4** and connect it to your PC. Make sure that the switches **SW0 - SW15** are in the off position. Finally, switch **SW16** to the on position.
Make sure that **JP2** is configured to use **USB** as power source. Furthermore, make sure **JP1** is configured to the **JTAG** mode. Insert a micro USB cable to **JC4** and connect it to your PC. Make sure that the switches **SW0 - SW15** are in the off position.
Finally, switch **SW16** to the on position.
![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-basys3/img/tutorial_basys6.png)
### 5.2.3 Test the Application
In the **Project Manager** toolbar click the **Hardware Manager** button which can be found in the Program and Debug subsection.
In the **Project Manager** toolbar click the **Open Hardware Manager** button which can be found in the Program and Debug subsection.
![](https://es.technikum-wien.at/iplat/testwiki/raw/master/getting-started-basys3/img/tutorial_basys7.png)
......