getting-started-basys3.md

-#### [Home](home) | [<Vivado Toolchain](vivado-toolchain) | [Getting Started - Zybo>](getting-started-zybo)
+#### [Home](home) | [<Tutorials](tutorials) | [Getting Started - Zybo>](getting-started-zybo)
 
 ***
 ![](./home/Logos.png)
@@ -8,14 +8,14 @@
 
 ## 5.1.1 Introduction
 
-The following section presents a tutorial for the Basys3 Development Board. 
+The following section presents a tutorial for the Basys3 Development Board.
 
 ### 5.1.1.1  Pre-requisites
 
 Following pre-requisites are necessary in order to work through this tutorial:
 
 + Vivado HLx 2015.4 (see [Vivado Toolchain](https://es.technikum-wien.at/iplat/wiki_public/wikis/vivado-toolchain) for an installation guide)
-+ Basys3 Development Board 
++ Basys3 Development Board
 + micro USB cable
 
 **Note:** Vivado 2016.1 was successfully tested with this tutorial.
@@ -72,7 +72,7 @@ A window should pop up once the bitstream generation finished successfully. Clic
 
 Make sure that **JP2** is configured to use **USB** as power source. Furthermore, make sure **JP1** is configured to the **JTAG** mode. Insert a micro USB cable to **JC4** and connect it to your PC. Make sure that the switches **SW0 - SW15** are in the off position.
 
- Finally, switch **SW16** to the on position. 
+ Finally, switch **SW16** to the on position.
 
 ![](./getting-started-basys3/img/tutorial_basys6.png)
 
@@ -95,8 +95,8 @@ After the bitstream is downloaded successfully the **DONE** LED of the Board sho
 
 This concludes the Basys3 Getting Started tutorial.
 
-<img src="./getting-started-basys3/img/tutorial_basys10.png" width="1000" height="750">
+![](./getting-started-basys3/img/tutorial_basys10.png)
 
 ***
 
-#### [Home](home) | [<Vivado Toolchain](vivado-toolchain) | [Getting Started - Zybo>](getting-started-zybo)
+#### [Home](home) | [<Tutorials](tutorials) | [Getting Started - Zybo>](getting-started-zybo)