Changes

Page history
update wiki authored by Felix Schroen's avatar Felix Schroen
Hide whitespace changes
Inline Side-by-side
getting-started-basys3.md
View page @ 15e15d94
#### [Home](home) | [<Vivado Toolchain](vivado-toolchain) | [Getting Started - Zybo>](getting-started-zybo) #### [Home](home) | [<Tutorials](tutorials) | [Getting Started - Zybo>](getting-started-zybo)
*** ***
![](./home/Logos.png) ![](./home/Logos.png)
...@@ -8,14 +8,14 @@ ...@@ -8,14 +8,14 @@
## 5.1.1 Introduction ## 5.1.1 Introduction
The following section presents a tutorial for the Basys3 Development Board. The following section presents a tutorial for the Basys3 Development Board.
### 5.1.1.1 Pre-requisites ### 5.1.1.1 Pre-requisites
Following pre-requisites are necessary in order to work through this tutorial: Following pre-requisites are necessary in order to work through this tutorial:
+ Vivado HLx 2015.4 (see [Vivado Toolchain](https://es.technikum-wien.at/iplat/wiki_public/wikis/vivado-toolchain) for an installation guide) + Vivado HLx 2015.4 (see [Vivado Toolchain](https://es.technikum-wien.at/iplat/wiki_public/wikis/vivado-toolchain) for an installation guide)
+ Basys3 Development Board + Basys3 Development Board
+ micro USB cable + micro USB cable
**Note:** Vivado 2016.1 was successfully tested with this tutorial. **Note:** Vivado 2016.1 was successfully tested with this tutorial.
...@@ -72,7 +72,7 @@ A window should pop up once the bitstream generation finished successfully. Clic ...@@ -72,7 +72,7 @@ A window should pop up once the bitstream generation finished successfully. Clic
Make sure that **JP2** is configured to use **USB** as power source. Furthermore, make sure **JP1** is configured to the **JTAG** mode. Insert a micro USB cable to **JC4** and connect it to your PC. Make sure that the switches **SW0 - SW15** are in the off position. Make sure that **JP2** is configured to use **USB** as power source. Furthermore, make sure **JP1** is configured to the **JTAG** mode. Insert a micro USB cable to **JC4** and connect it to your PC. Make sure that the switches **SW0 - SW15** are in the off position.
Finally, switch **SW16** to the on position. Finally, switch **SW16** to the on position.
![](./getting-started-basys3/img/tutorial_basys6.png) ![](./getting-started-basys3/img/tutorial_basys6.png)
...@@ -95,8 +95,8 @@ After the bitstream is downloaded successfully the **DONE** LED of the Board sho ...@@ -95,8 +95,8 @@ After the bitstream is downloaded successfully the **DONE** LED of the Board sho
This concludes the Basys3 Getting Started tutorial. This concludes the Basys3 Getting Started tutorial.
<img src="./getting-started-basys3/img/tutorial_basys10.png" width="1000" height="750"> ![](./getting-started-basys3/img/tutorial_basys10.png)
*** ***
#### [Home](home) | [<Vivado Toolchain](vivado-toolchain) | [Getting Started - Zybo>](getting-started-zybo) #### [Home](home) | [<Tutorials](tutorials) | [Getting Started - Zybo>](getting-started-zybo)