|
|
#### [Home](home) | [<Vivado Toolchain](vivado-toolchain) | [Getting Started - Zybo>](getting-started-zybo)
|
|
|
#### [Home](home) | [<Tutorials](tutorials) | [Getting Started - Zybo>](getting-started-zybo)
|
|
|
|
|
|
***
|
|
|

|
... | ... | @@ -8,14 +8,14 @@ |
|
|
|
|
|
## 5.1.1 Introduction
|
|
|
|
|
|
The following section presents a tutorial for the Basys3 Development Board.
|
|
|
The following section presents a tutorial for the Basys3 Development Board.
|
|
|
|
|
|
### 5.1.1.1 Pre-requisites
|
|
|
|
|
|
Following pre-requisites are necessary in order to work through this tutorial:
|
|
|
|
|
|
+ Vivado HLx 2015.4 (see [Vivado Toolchain](https://es.technikum-wien.at/iplat/wiki_public/wikis/vivado-toolchain) for an installation guide)
|
|
|
+ Basys3 Development Board
|
|
|
+ Basys3 Development Board
|
|
|
+ micro USB cable
|
|
|
|
|
|
**Note:** Vivado 2016.1 was successfully tested with this tutorial.
|
... | ... | @@ -72,7 +72,7 @@ A window should pop up once the bitstream generation finished successfully. Clic |
|
|
|
|
|
Make sure that **JP2** is configured to use **USB** as power source. Furthermore, make sure **JP1** is configured to the **JTAG** mode. Insert a micro USB cable to **JC4** and connect it to your PC. Make sure that the switches **SW0 - SW15** are in the off position.
|
|
|
|
|
|
Finally, switch **SW16** to the on position.
|
|
|
Finally, switch **SW16** to the on position.
|
|
|
|
|
|

|
|
|
|
... | ... | @@ -95,8 +95,8 @@ After the bitstream is downloaded successfully the **DONE** LED of the Board sho |
|
|
|
|
|
This concludes the Basys3 Getting Started tutorial.
|
|
|
|
|
|
<img src="./getting-started-basys3/img/tutorial_basys10.png" width="1000" height="750">
|
|
|

|
|
|
|
|
|
***
|
|
|
|
|
|
#### [Home](home) | [<Vivado Toolchain](vivado-toolchain) | [Getting Started - Zybo>](getting-started-zybo) |
|
|
#### [Home](home) | [<Tutorials](tutorials) | [Getting Started - Zybo>](getting-started-zybo) |